garage door opener JAGUAR XJ 2004 X350 / 3.G Owners Manual

Security and Locks
Ignition Switch . . . . . . . . . . . . . . . . . . . . . . . . . . 2 - 3
Vehicle Security . . . . . . . . . . . . . . . . . . . . . . . . . 2 - 4
Key Transmitter . . . . . . . . . . . . . . . . . . . . . . . . . 2 - 4
Keys . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 - 7
Door Locks and Handles . . . . . . . . . . . . . . . . . . . 2 - 8
Alarms and Audible Signals. . . . . . . . . . . . . . . . 2 - 15
Security Features . . . . . . . . . . . . . . . . . . . . . . . 2 - 17
Luggage Compartment Emergency Release . . . . 2 - 19
Garage Door Opener Transceiver . . . . . . . . . . . 2 - 20

2 - 20 Security and Locks
Garage Door Opener
Transceiver
The garage door opener transceiver is
located in the overhead console.
The transceiver can be programmed to
transmit the radio frequencies of up to
three different transmitters used to
activate garage doors, entry gates, home
lighting, security systems, or other radio
frequency operated devices.Although this section mainly describes
the procedures for the garage door
opener, it also equally applies to the
previously mentioned applications.
In some countries this feature is also
known as HomeLink
® Universal
Transceiver.
For information, or for assistance, contact
your Jaguar Retailer or the supplier by
phone or via the internet. For details
see Information and Assistance on
page 2 - 23.
!WARNING:
1. Do not use the transceiver with any garage door opener that lacks
the safety stop and reverse feature
as required by safety standards.
A garage door opener which
cannot detect an object, signalling
the door to stop and reverse, does
not meet current safety standards.
Using a garage door opener
without these features increases
risk of serious injury or death. 2. When programming the
transceiver to a garage door
opener or entry gate, make sure
that people, the vehicle and
objects are out of the way to
prevent potential harm or damage
as the gate or garage door will
activate during the programme.
3. This device may suffer from interference if operated in the
vicinity of a mobile or fixed station
transmitter. This interference is
likely to affect the hand-held
transmitter as well as the in-car
transceiver.

Security and Locks 2 - 21
Before Programming
Caution: When programming a
garage door opener or entry gate that
may require you to press and re-press
the hand-held transmitter (cycle),
unplug the device during the ‘cycling’
process to prevent possible motor
failure.
It is recommended that for best results,
fit a new battery to the hand-held
transmitter of the garage door opener
(or other device) before programming.
If your garage door opener receiver
(located in the garage) is equipped with
an antenna, ensure that the antenna is
hanging straight down.
To Erase All Programming
For first time progra mming, ensure that
the engine is switched off:
1. Turn the ignition switch to position ‘I’.
2. Press and hold th e two outer buttons
on the garage door opener in the
overhead console. Keep the buttons
pressed, the indicator light will
illuminate. The indicator light is part
of the middle button in the garage
door opener in the overhead console.
3. Release the buttons when the lights
begin to flash (this will take
approximately 20 seconds).
All memories in the garage door opener
have now been cleared.
Note: Do not perform this procedure
when programming the additional garage
door opener buttons.
Programming the Vehicle
Ensuring that the engine is switched off:
1. Turn the ignition switch to position ‘I’.
2. Hold the end of the original garage door opener hand -held transmitter
approximately 2 to 6 inches (5 cm to
15 cm) away from the transceiver in
the overhead console, keeping the
indicator light in view.

2 - 22 Security and Locks
3. Using both hands, simultaneously press and hold both the desired garage
door opener button on the overhead
console and the hand -held transmitter
button. Keep both buttons pressed.
The light will flash, slowly at first and
then change to a fast flash. When the
indicator light flashes rapidly, release
both buttons. The rapid flashing light
indicates successful programming.
4. If, after 60 seconds, the indicator light does not flash rapidl y, release both the
transceiver and the hand-held
transmitter buttons and repeat the
procedure starting with Step 2.
However, position the hand-held
transmitter at a different angle and/or
distance.
5. Press and hold the programmed overhead console garage door opener
button and observe the indicator light:
• If the indicator light is solid/continuous, programming is
complete. Your device should
activate when the garage door
opener button is pressed and held
for 1 to 2 seconds and then
released. • If the indicator light blinks rapidly
for 2 seconds and then turns a
solid/continuous light, proceed
with the following programming
instructions for ‘rolling code’
device equipment.
Note: To programme additional garage
door opener buttons, begin at Step 2.
Rolling code device equipment
programming
Note: A second person may make the
following steps quicker and easier as once
the button has been pressed there are
30 seconds only in which to complete
Step 3.
1. At the garage door opener receiver (motor head unit) in the garage, locate
the ‘learn’ or ‘smart’ button/switch.
Note: The name of the button/switch
may vary between manufacturers.
2. Press and release the ‘learn’ or ‘smart’ button.
3. Return to the vehicle and firmly press and hold the programmed garage door
opener button for 2 seconds and
release. 4. Repeat the press/hold/release
sequence 3 times to complete the
learning/training process.
The garage door opener in the overhead
console should now activate the ‘rolling
code’ device.
Reprogramming a sing le garage door
opener button
To programme a device to a previously
trained button:
1. Press and hold the desired pre- programmed garage door opener
button for at least 20 seconds, but no
longer than 30 seconds, until the
indicator light begins to flash.
2. Without releasing the overhead console button, position the hand-
held transmitter approximately 2 to
6 inches (5 cm to 15 cm) away from
the transceiver in the overhead
console, keeping the indicator light in
view.
3. Carry out Step 3 of programming the vehicle, see column 1.

Index
Garage door opener transceiver . . . . . . . . . . . . . . . . . . . 2 - 20
– information and assistance . . . . . . . . . . . . . . . . . . . . . 2 - 23
– programming . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 - 21
– rolling code programming . . . . . . . . . . . . . . . . . . . . . . 2 - 22
Gearshift interlock . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 - 3
General driving information . . . . . . . . . . . . . . . . . . . . . . 4 - 59
General information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 - 3
Generator . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 - 13
Glass surfaces – cleaning . . . . . . . . . . . . . . . . . . . . . . . . . 7 - 23
Glove compartment . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 - 13
Grease or tar removal . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 - 23
H
Hazard warning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 - 27
Head restraint adjustment . . . . . . . . . . . . . . . . . . . . . . . . 3 - 4
Headlight powerwash . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 - 32
Headlining – cleaning . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 - 22
Heated steering wheel . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 - 5
Hood release . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 - 4
Horn . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 - 40
IIgnition switch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 - 3
Illuminated entry/exit . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 - 28
Immobilisation system
– programmable key . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 - 7
– status light . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 - 7
Inertia switch . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 - 3
Instruments . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 - 3
– engine temperature . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 - 4
– fuel level gauge . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 - 3
– odometer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 - 3
– speedometer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 - 3
– tachometer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 - 3
– warning lights . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 - 5
Interior care . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 - 22
Interior features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 - 37
– accessory power points . . . . . . . . . . . . . . . . . . . . . . . . 4 - 37
– centre console . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 - 38
– cigar lighter and ashtray . . . . . . . . . . . . . . . . . . . . . . . 4 - 37
– cupholders . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 - 38
– rear armrest . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 - 39
– rear sunblind . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 - 40
– side sunblinds . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 - 41
– sun visors and vanity mirrors . . . . . . . . . . . . . . . . . . . . 4 - 37
– sunglasses stowage . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 - 40
Interior lighting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 - 27
Interior rear view mirror . . . . . . . . . . . . . . . . . . . . . . . . . . 3 - 9
J